Why is my resin always bendy and tacky？

Why is my resin always bendy and tacky？

Tips：

1. Make sure the measurement is accurate. The mixing ratio is 1:1 by volume. A measuring cup is recommended.
2. Mix the resin properly. Please stir it slowly for at least 3 minutes until no swirls are seen, Make sure to scrape the cup to stir thoroughly.
3. Do not work in cold temperatures, which will cause the products difficult to work with and prevent the resin from curing properly.
4. Do not add too much liquid colorants. Never add more than 6% of the total volume of the mixed resin.
5. Do not work in mass. The more the 2 parts you mix, the more heat they will release. Therefore it may cause a flash cure, which means the resin will cure in a few minutes and you cannot work with it then.
6. For casting molds, please do not pour over 200ml at a time, it may cause a flash cure. And do not cast for less than 3mm, it may not cure properly. 7, Do not use any water-based colorants and additives in the resin.
7. We recommend to pour in multiple layers for deep or large molds, waiting 3~5 hours in between each pour.
8. Thin layers and small molds may take longer to cure, extend the curing time for 1 or 2 more days if necessary.